DIY Trailing Arm Mounts(sold as a pair)

DIY Trailing Arm Mounts(sold as a pair)

Build your own trailing arm setup with a solid mount made from 1/4-inch plate. These mounts give you a straightforward starting point for a custom suspension build. 

The mount is 14 inches long with 6-inch bolt-hole spacing and added support through the middle. Adjustable to fine tune your suspension based off how much travel you want. You must run some type of anti-wobble setup with these mounts as part of your finished build.

Weld-on DIY design. Ships in pieces, ready for your custom finish and final setup.

Specs

• Fitment: DIY/custom trailing arm builds
• Material: 1/4-inch plate
• Length: 14 inches
• Bolt-hole spacing: 6 inches apart
• Support: Center support included
• Install type: Weld-on
• Shipping condition: Ships ready for fabrication and finish
• Sold as: Pair

Custom engraving available for +$25.

Made in-house by Bama Beef Fab — built to keep your rig bouncing off rev limiters and trees longer.